1. Check all fluid levels.

2. Check all belts for wear and cracks (replace if needed).

3. Check all coolant hoses for cracks and rub points.

4. Check all wiring harnesses to make sure they are secured.

5. Inspect wiring for corrosion and loose connections.

6. Reapply dielectrical grease where required.

7. Check freon lines and compressor for leaks.

8. Clean exterior of radiator, engine oil cooler, trans cooler with compressed air.

9. Clean battery connections and apply protectant.

1. Inspect ac/heater hoses.

2. Check ac drain for restriction.

3. Inspect fuel fill hoses for wear & security.

4. Check all harnesses for security & wear points.

5. Check under chassis grounds for corrosion (clean & reseal if needed).

1. Inspect all gauges and warning lights for proper operations.

2. Check all backlighting & panel lighting.

3. Check dome light, map light, spotlight, etc. for proper operation.

4. Check all audible alarms.

5. Check front console switches, gauges & indicators.

6. Check siren operations all modes for proper operation.

7. Check all battery connections, behind seat & battery switch condition.

1. Inspect batteries & cables (load test batteries), check alternator output (load test alternator).

2. Check all emergency lighting operations, including lens condition.

3. Check all exterior compartment lights for proper operation.

4. Check all chassis lighting, headlights, marker lights, turn signals, four way backup light, including backup alarm.

5. Check all door switches and lubricate.

1. Inspect J-box for loose connections.

2. Inspect shoreline, gfi receptacles, battery charger for proper operation.

3. Inspect all 12-volt outlets.

4. Inspect rear console switches and indicators.

5. Inspect rear heat/ac for proper operation including blower.

6. Check all interior lighting, dome lights, fluorescent lighting, etc.

1. Lubricate & adjust all chassis & module hinges & latches (interior & exterior).

2. Lubricate battery drawer slides.

3. Inspect module sealant underneath.

4. Inspect cab to module gaskets.

5. Inspect mounting bolts and rubber donuts.

6. Check all screws, door handles, grabrails, door liners, etc.

Cost for Maintenance Agreement.......... $275.00

Floors stripped and sealed.....................$325.00
(must be done at our facility)

All parts will be an additional charge.
After initial inspection, we can fax or call with a
detailed  list of items and parts to be completed.
(All parts will be saved & sent back for your inspection.)

Discounts
2 unit discount...... $10.00 each
3 or more units...... $15.00 each

We offer 3, 6 & 12 month programs, as well as customized
maintenance and warranty programs to fit your needs.

Other Services Include

• Electrical Components - Add-Ons
• New Electrical Systems
• New Lighting Packages (Lightbars, Emergency Lighting, Etc.)
• New Beltlines (Layout and Design)
• New Pinstriping, Lettering, Etc.
• Complete Blasting & Painting
• Maintenance Programs
• New Upholstery
• New Vinyl Flooring (Tarkett, Congoleum, Lonseal)
• In House Repair/Service
• Free Technical Service
• General Add Ons